SAUTER HBA 100-0. Analogue Shore hardness tester

• Typical application: measurement of penetration (Shore)
• Particularly recommended for internal comparison measurement. Standard calibrations e. g. to DIN 53505 are often not possible because of very narrow standard tolerances
• Shore A rubber, elastomers, neoprene, silicone, vinyl, soft plastics, felt, leather and similar material
• Shore D plastics, formica, epoxides, plexiglass etc.
• Shore A0 foam, sponge etc.
• Max mode: Holds the maximum value in the display
• Point mode: Shows one instant value
• Can be attached to the test stands SAUTER TI-A0 (for Shore A and A0), TI-D. (for Shore D)

hardness comparison plates see SAUTER AHBA-01 and SAUTER AHBD-01